Precautions for installation of cone sleeve pulley drive
Time:
2023-06-06
1. Before installation, check and measure the length of the inner hexagonal bolt used for assembly to ensure that it can withstand the bottom end of the blind hole of the cone sleeve after tightening, to ensure tight fitting of the cone surface, and to ensure that the bolt is subjected to reverse thrust from the bottom end of the blind hole, producing the same anti loosening effect as the double nut principle. 2. After tightening the pulley, check and adjust the relative positions of the main and driven pulleys by pulling a wire to ensure that the two pulleys are in the same plane and the belt tension is moderate. 3. The pulley cover should be intact and firmly installed to ensure that belt breakage or pulley loosening during operation can lead to major safety accidents. 4. The cone sleeve is a vulnerable component, and after long-term operation, the inner hole and chain groove may be damaged. Before each assembly, it should be inspected and any defects found should be replaced with spare parts in a timely manner.
1. Before installation, check and measure the length of the inner hexagonal bolt used for assembly to ensure that it can withstand the bottom end of the blind hole of the cone sleeve after tightening, to ensure tight fitting of the cone surface, and to ensure that the bolt is subjected to reverse thrust from the bottom end of the blind hole, producing the same anti loosening effect as the double nut principle.
2. After tightening the pulley, check and adjust the relative positions of the main and driven pulleys by pulling a wire to ensure that the two pulleys are in the same plane and the belt tension is moderate.
3. The pulley cover should be intact and firmly installed to ensure that belt breakage or pulley loosening during operation can lead to major safety accidents.
4. The cone sleeve is a vulnerable component, and after long-term operation, the inner hole and chain groove may be damaged. Before each assembly, it should be inspected and any defects found should be replaced with spare parts in a timely manner.